In Profile, leave all the profile boxes clicked and, then click Next.Ĭreate a new firewall rule by selecting Outbound Rules-> New Rule… Select Require the connections to be encrypted, and then click OK. Select Allow the connection if it is secure, and click Customize. Select the ip addresses/ranges this rule applies to, and then click Next. Select the serverside inbound port (in this example, SMB: TCP 445) and click Next. Select All Programs, and then click Next. Right-click Inbound Rules, and then click New Rule. This means that there is authentication as to the validity of the sender, but the data itself is not being encrypted with IPSEC. In the Monitoring section of the Windows firewall, under Security Associations->Main Mode, you should now see an authentication between the two machines.Īlso note in the Security Associations, under Quick Mode, ESP Encryption is set to None. Note: There might be a slight pause with your connection as the security association happens. Test your connection to make sure it still works. (Everything is identical, including the IP ranges and Endpoint 1 and 2). Repeat the server side setup (steps 3-14 above in the Create a Connection Security Rule procedure) for the client. Set Up the Client-side Security Association In the When does this rule apply box, leave all the boxes checked, and then click Next. Since Endpoint 1 is the server, only define the port on Endpoint 1. In the To which ports and protocols does this rule apply box, select the ports/protocols for your service (we will use SMB, TCP 445 for this example), and then click Next. You'll see the New Connection Security Rule Wizard: Authentication Method window again, click Next. In Customize Advanced Authentication Methods, click OK. In Add First Authentication Method, select Computer certificate from this certificate authority and then do the following: In First Authentication Method, click Add. In the Authentication Method box, select Advanced, and then click Customize. Select Require authentication for inbound and outbound connections, and then click Next. In the Which Computers are Endpoint 2 box, enter the client(s) IP address or range.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |